Norton Internet Security / Norton AntiVirus

[Speedyswede]

Hi!

I have bought an accesspoint D-link DAP-1353 to enhance my wireless network at home. But its just not possible to access the admin web page at the AP. I suspect that it is the firewall in NIS 2010 that is blocking the AP. But I have tried to turn it off without any success. I run Win7 professional.

Any idea somebody?

[mdturner]

Hi Speedyswede

Welcome to the Norton Community Forums

Do you see the new access point in the Network Security map in NIS? If so, you should set it to Full Trust.

[Speedyswede]

I am a bit of neewbe on this. Where do I find this security map?

[Mathew_Issac]

To Open Norton Security Map, follow the steps provided below:

Open Norton Internet Security

Under  Network, select Network Security Map

Check Dlink DAP is listed under Network Details tab

[Speedyswede]

Now I found the map! What should I expect to see here? I have a home network (in which the accesspoint is connected to) with a D-link router, a network printer aNAS etc. I can se none of these units.

[Speedyswede]

I have found the acesspoint in the map and I have set the thrust level to full. Then I guess there is some other reason than NIS tha I cant se the admin page in the browser?

[mdturner]

---

Speedyswede wrote:

I have found the acesspoint in the map and I have set the thrust level to full. Then I guess there is some other reason than NIS tha I cant se the admin page in the browser?

---

Hi Speedyswede

If you are connecting the AP to extend your home network you would be better to set it up as a repeater - most D-link APs can be set up as repeaters and their web site has good tutorials on how to do this.

[Speedyswede]

---

Their web site has good tutorials on how to do this.

---

Yes! But the problem is still that I can not reach the administrator web page on the unit. Something is blocking it...

[mdturner]

---

Speedyswede wrote:

---

Their web site has good tutorials on how to do this.

---

Yes! But the problem is still that I can not reach the administrator web page on the unit. Something is blocking it...

---

Hi Speedyswede

Have you tried connecting directly via ethernet cable. Are you trying to access using the default IP address 192.168.0.50 ?

[Speedyswede]

Yes, that is what i am doing. I have connnected the AP to the router with an ethernet cable to get acces to the configuration in it.