Other Norton Products

[dr431]

I have a pc with multiple hdd's and created a task that creates recovery points for each one. Ghost can run a command file after each individual recovery point has been created, but I want to run a single command file after all of the recovery points have been created. Is there a way to do this?

[redk9258]

Can't you just add the command to the last command file on a second line?

[dr431]

I've only tried to set up and run command files through the gui. As far as I've been able to tell, ghost runs the same command file for each recovery point. I want to run my command file once after all the recovery points are finished.

[redk9258]

So if you have a different backup for each drive or at least the last one, can't you choose a different command file?

[DaveH]

I think you must be using one task to image all the drives.

As Red suggested, make a seperate task for the last drive and schedule it to run at a later time and add your command file to that one.

Dave