Hi everyone
I was reading this thread and i was finding it really helpful until I get to a part that was not discussed.
as you can see from the image below, Disk 0 (this is my drive that I want to clone to DISK 1)
Initially I had set the drive to be regconised... then I noticed in the link above, to delete any drives and set it so the space is not allocated (to the target drive)
After doing so, I had about 470GB of space on DISK1...
I went through the process well to add the system section, as you can see above 199MB an Ghost 15 successfully partitioned the drive.
thing is now though, when I look at the computer management area, it says that there is a collision with another disk online... ALSO, when I try to restore the main system, I don't see my drive... as shown below
I'm assuming at this point, I need to ALLOCATE the DISK1 via the disk management section to make this partition active? then i'll be able to restore my 1TB drive data on to DISK1 drive which is 500MB...
Thanks in advance
Bob