I had been having problems getting full system scans to complete since upgrading to Norton Security. I have multiple drives and every time the scan would stop on the third drive being scanned. I tried creating a custom scan for that drive and ran it. The scan ran for a little while and the counter stopped increasing. On checking the log file I saw that a submission was sent to the Norton Community Watch and was pending. I looked further and every scan before that I had to cancel had the same issue. Sometimes a response was received from the community watch and sometimes, even after hours, no reply was received. I checked the drive for errors and bad sectors and there were no problems with the drive. I created a custom scan for that particular drive and ran it. It stopped counting up after a short while and low and behold a Norton community watch submission was pending. I terminated the scan, rebooted and again the same problem. I went into administrative settings and turned off Norton community watch and the scan completed. Is anyone else having this issue? Is there something going on with Norton community watch? I would like to turn it back on but not it my scans won't complete.