I thought I'd share a problem I had, and its solution, with Ghost version 14. I created a recovery point set from a 320 gig drive and restored it to a new 500 gig drive. No problem. I booted the 500 gig drive and then went into disk management and enlarged the partition to make use of the entire drive. I then removed the drive (computer is a laptop with room for only one drive) and reinserted my original 320 gig drive. The 500 gig drive was stored as a backup. A month later when I tried to repeat the create and recover sequence, I got a error, "EA 390 2DC: Attempt to handle too many NTFS attributes".
I created the problem when I resized the partition on the larger drive and then later tried to recover a new image made from the smaller drive. After a bit of searching for a solution, I came across the answer I needed. Go to the following address and follow the steps under "solution": http://www.symantec.com/business/support/index?page=content&id=TECH127919
I don't know if this is a common problem or not, but zeroing out the target disk solved the problem.