I've been using NIS 2013 on my computer since it's release. I just got 2 new hard drives & put them into a RAID 0 array.
Everything works great until I install NIS 2013 in Windows 8 (64 bit). As soon as NIS 2013 finished installing & started up my computer keeps blue screening. It reboots, logs back in & as soon as NIS 2013 loads up it blue screens again.
The only way I've been able to fix it is to boot to my Windows 8 media, run System Restore & restore to the point before NIS 2013 was installed.
All of my drivers are up to date. I'm using an Asus Crosshair IV Formula (AMD) motherboard & the built in onboard RAID.
Has anyone else encounted anything like this before? It's VERY frustrating. I hate to lose my RAID just because of NIS. Any ideas or suggestions would be appreciated.