I need to open another port in Firewall as I run Team Viewer and have a local server both on th e same port (80)
I found this in an older thread but it doesn't match my current version of 360:
Check the steps below to create a rule as per the specifications you have provided:
1. Start Norton 360.
2. Click Settings.
3. Click Firewall Protection. No Firewall Protection tab just "Firewall"
4. On the General Rules tab, click Add. If I click "General" there is no "add" option so can get no further!
5. Click Permit, and then click Next.
6. Click Connections to and from other computers, and then click Next.
7. Click Only Specific Computer or Web sites listed below and then click Add.
8. Select Individually, enter the Ip address of the server computer and click Ok.
9. Click Next.
10. Click Only the types of communication or ports listed below and then click Add.
11. In the Specify Ports window, be sure the Individually specified ports and Remote option buttons are selected. In the port entry field below, enter 7000,55402.
12. Click OK, and then click Next.
13. Type the description of the network into the box, and then click Next.
12. Click Finish.
14. Select the new firewall rule for the network in the list and click Move Up until the rule is listed at the top of the list.
15. Click Apply and then click Close.
Any advice appreciated
Thanks
mitchell65